P0098 Code just after Whipple install

[alrodri8]

So I just finished installing my Whipple kit and have flashed to the whipple tune successfully, with one issue. I have a P0098 code. I would normally give Whipple a call, but it is the weekend and am wondering if I can figure it out before it ends. What could be the issue with the install? I also pinched my MAF cable a bit and maybe that could be the problem, I plan on removing the loom from it tomorrow to find out if that is what is causing this code. Anyone else have this issue before?:doh:

Sponsored

 

[dmxxcy]

You forgot to plug in a sensor.

 

[Roh92cp]

p0098 code is air intake temp sensor circuit is high. You have 2 air temp sensors one is integrated with the MAF (I suspect it's this one) and the other comes with the Whipple's kit in the drivers side manifold. Check to make sure they are connected properly first then move in the the possible pintch/damaged wire you speak of.

 

[alrodri8]

p0098 code is air intake temp sensor circuit is high. You have 2 air temp sensors one is integrated with the MAF (I suspect it's this one) and the other comes with the Whipple's kit in the drivers side manifold. Check to make sure they are connected properly first then move in the the possible pintch/damaged wire you speak of.

Alright, Thanks. Will look into this today.

 

[ramirj2]

Check the plug close to the fuel rail driver side
The harness runs behind block close to the firewall

 

[alrodri8]

Solved the issue. I plugged the ACT sensor into the driver side 3 pin connector. It was suppose to be plugged into the passenger side. Thanks for the info everyone! problem solved.

 

[Roh92cp]

Awesome, nice when it's a simple solution.

Sponsored