stevec
Well-Known Member
- Thread starter
- #871
Yeh, as Manders Mustang says, we took away the bare minimum. Just enough for where the vent dips down into the hood.Too much original material taken away from hood, which means less surface area for the vents to bond to, not sure why there was so much original material cut away for this mod :shrug:
It simply a case of not enough bond being put in to fill the gap between the vent and the hood.
You can see from the pic that it is well bonded at the back of the vent, the bit in the middle does nothing and then the front bit obviously bonded originally but not well enough. I reckon that if we bond a plastic block on to the hood towards the front of the vent and then glue the whole area, it will be fine.
Will get it right next time.
Sponsored