Fishtales
Well-Known Member
- Joined
- Nov 20, 2020
- Threads
- 12
- Messages
- 282
- Reaction score
- 299
- Location
- Boston, MA USA
- First Name
- Dan
- Vehicle(s)
- 2001 Harley, 1964 Volkswagen Beetle, 2016 Toyota Avalon
- Thread starter
- #1
Hi,
I spoke with Pilotgore (he came up with the idea for the Mach1 oil funnel kit) about potentially replicating the solid grill plates (where driving lights could be installed) with holes in them for additional airflow. I believe he would design a new set of plates, then on-demand 3D print and make available to buy as he did with the funnel kit.
In order to do this, he would either require a plate set or a dimensional drawing of the two plates as well as the grill pattern that would be in the center to allow air flow.
Unfortunately, my car continually is getting pushed out and now I won't have until mid April at best.
Would it be possible for someone that has removed the pieces to loan them to him for the project (I'm sure he will arrange to return once modeling is complete) or provide a detailed dimensional drawing with close up pictures to enable design and fabrication?
tx
I spoke with Pilotgore (he came up with the idea for the Mach1 oil funnel kit) about potentially replicating the solid grill plates (where driving lights could be installed) with holes in them for additional airflow. I believe he would design a new set of plates, then on-demand 3D print and make available to buy as he did with the funnel kit.
In order to do this, he would either require a plate set or a dimensional drawing of the two plates as well as the grill pattern that would be in the center to allow air flow.
Unfortunately, my car continually is getting pushed out and now I won't have until mid April at best.
Would it be possible for someone that has removed the pieces to loan them to him for the project (I'm sure he will arrange to return once modeling is complete) or provide a detailed dimensional drawing with close up pictures to enable design and fabrication?
tx
Sponsored
