Lund Boost + Wiring

[TheHydro]

I am installing a boost + box in my car and need some help with the wiring. I want to wire in my AEM iat sensor to the second input in the boost box. However, the Iat sensor only has two wires and the boost box has 3 wires (black-ground, red-5v source, yellow-signal wire) how do I wire the sensor to the box so I can read my IAT2 on my ngauge?

Sponsored

 

[Plimmer]

I am installing a boost + box in my car and need some help with the wiring. I want to wire in my AEM iat sensor to the second input in the boost box. However, the Iat sensor only has two wires and the boost box has 3 wires (black-ground, red-5v source, yellow-signal wire) how do I wire the sensor to the box so I can read my IAT2 on my ngauge?

One of the sensor wires goes to ground and the other goes to the yellow signal wire, either one doesn't matter.

You will need to input the analog calibration details for the AEM to make it display properly, I don't know what it is.

 

[TheHydro]

I have the calibration details from AEM. Do you have any idea how I put them into the Ngauge?

 

[Plimmer]

I have the calibration details from AEM. Do you have any idea how I put them into the Ngauge?

See pg17:
http://e-motionproducts.com/updates/nGauge/nGauge_Manual.pdf

 

[TheHydro]

Thanks for the help

Sponsored