Lowest Maintenance Most Reliable FI

[Dominant1]

I change my D1x every 4000 miles, it's so easy only takes 15minutes.

Sponsored

 

[Avispa]

Had 50,000 trouble free miles on the last Terminator. Whipple 2.3 with 3" upper pulley, stock lower. Made 16# boost. Never a hiccup. The '16 is still too new to me to figure out how good VMP Gen II blowers are. Guessing it has about 10,000 on it. No troubles at all for now.

 

[Aaron1085]

So... I’m new to the mustang AND the Whipple 3.0 world. That said, the previous owner had a Stage 2 installed which runs a 3.875 pulley. Where, with the stock tune, is the psi at on this thing?
So far so good, runs SO solid and snappy.

 

[engineermike]

There is a chart in the back of the Whipple manual that shows pulleys and boost level. Iirc, 3.875 is 11 psi on the crusher TB or 10 psi on the stock TB.

 

[TX-Ripper]

There is a chart in the back of the Whipple manual that shows pulleys and boost level. Iirc, 3.875 is 11 psi on the crusher TB or 10 psi on the stock TB.

with stock exhaust

Sponsored