UnlivedAttack
New Member
- Thread starter
- #1
I noticed my hood is higher in the front left side than the right side. Do you guys know if those hood pins are adjustable so I can make that left side flush with the bumper panel?
Sponsored
Sponsored
Hood pin question
- Thread starter UnlivedAttack
- Start date
- Watchers 2
Snoopy49
Well-Known Member
- Joined
- Jul 24, 2019
- Threads
- 56
- Messages
- 4,024
- Reaction score
- 6,051
- Location
- California
- First Name
- Earl
- Vehicle(s)
- 2013 GT500 - SOLD and 2020 GT500 - SOLD
I wonder if the rubber bumper on that side is screwed to far out and is holding up the corner of the hood?
marklboris
Well-Known Member
- Joined
- Jul 16, 2019
- Threads
- 3
- Messages
- 670
- Reaction score
- 1,020
- Location
- Sonora, CA
- First Name
- Mark
- Vehicle(s)
- ______ '20 Shelby GT500 FPB '24 Mach-E GTP GGM
- Vehicle Showcase
- 1
^^^ Yes what Earl said. You adjust that rubber bumper by turning it clockwise (down) to allow your hood to drop a little. Only turn it a 1/4 turn at a time until you get the result you want. That's one of the first things I do when I get a car is adjust the body panels. I had to move the front of my right front fender out a bit to allow it to have the same gap between the hood the entire length and to match the left side. Also had to adjust the bumper on the trunk lid to be level with the left rear fender.
Sponsored
