Headers Install

[KilluminatiDre]

You're supposed to do it when you're taking the OEM studs out after the OEM manifold has been removed. Clean up all the holes for it before installing the after markets headers so that all your bolts thread in smooth. Once you already have the headers in you're sorta hosed. You might try barely threading the bolt in and back out to see if that helps. If not you're going to have to pull the header back out and run a tap through it.

Yea I couldn't get an oem bolt to line up properly because it hits the header. I have to take it to the shop for rethread. $425

Sponsored

 

[Schu]

There's not a specific kit, but I have ARP 12 point's that I used. There was a thread on it somewhere that I posted all the information in. You even posted in that thread. :lol:

It was this part # ARP 773-1002

lol...

I know, I just wanted to see if OP knew.:clap2:

 

[KilluminatiDre]

lol...

I know, I just wanted to see if OP knew.:clap2:

I did not know, thanks.

 

[Ultrakla$$ic]

Yea I couldn't get an oem bolt to line up properly because it hits the header. I have to take it to the shop for rethread. $425

:eyebulge: sorry to hear that. Hope it all goes well.

 

[KilluminatiDre]

:eyebulge: sorry to hear that. Hope it all goes well.

Yea it's alittle disappointing that the hard work on that side has to be un-done. I love the new sound and got compliments already but the slight hissing sound right under me is pretty annoying. I probably won't be able to get this fixed until the first though, too many moving expenses.

 

[Choking_Victim]

Yea I couldn't get an oem bolt to line up properly because it hits the header. I have to take it to the shop for rethread. $425

where you take it ?

 

[KilluminatiDre]

where you take it ?

I haven't taken it yet but I will be Jay at AZMP in Glendale. Hopefully he can get me in on the 30th.

 

[Choking_Victim]

I haven't taken it yet but I will be Jay at AZMP in Glendale. Hopefully he can get me in on the 30th.

Right on heard good things about them.

 

[SLA]

Yea I couldn't get an oem bolt to line up properly because it hits the header. I have to take it to the shop for rethread. $425

Why not just remove the header yourself and buy a cheap tap and die set?

http://m.harborfreight.com/60-piece-sae-metric-tap-and-die-set-35407.html

 

[KilluminatiDre]

Why not just remove the header yourself and buy a cheap tap and die set?

http://m.harborfreight.com/60-piece-sae-metric-tap-and-die-set-35407.html

I thought about it but I don't want to potentially make it worse. I really don't have any experience with that.

Sponsored