JerseyDevil
Well-Known Member
- Joined
- Nov 21, 2014
- Threads
- 9
- Messages
- 212
- Reaction score
- 129
- Location
- Marlton NJ
- Vehicle(s)
- 2015 Race Red Ecoboost Mustang
please PM me his email...Check your PM.
Sponsored
please PM me his email...Check your PM.
I added his email to my original post, but here it is: erikastevens at cox.netplease PM me his email...
I have his business card which has a different cox.net email address. Maybe this is the business one? Check it out and for everyone else that wants to buy:I added his email to my original post, but here it is: erikastevens at cox.net
Can you send me his email address too? I'd like to order one.Awesome. Where can I find his email address?
His business card is aboveCan you send me his email address too? I'd like to order one.
Can the pony be replaced on the trunk as well?
What do you mean drilling holes? The ones that are there don't line up or just need to be made bigger?Only hard part was drilling the holes in the back.
That was only on the early ones that were made for the 11-14. He has since revised the post locations and they should pop right in.What do you mean drilling holes? The ones that are there don't line up or just need to be made bigger?
I get more comments on this than anything else...and I rather like being able to say, 'they aren't being sold online any longer'.My gardener noticed mine. He may be the only person I know who told me he noticed thus far. The silver is subtle, unless someone is really looking at your whole front end.
How much was it and when did he say it would ship out?Send the money order for mine today!!!! I've seen the skeleton pony at a few local shows. This is going to be different! #Excited!
I'm getting two. One for the front grill and one for the trunk.
I just e-mailed him and bought a DIB blue one for $62. Sending out the cashier's check tomorrow morning. Didn't discuss a time frame yet. Can't wait!How much was it and when did he say it would ship out?
If you get the '15 version, they do line up very nicely with the stock holes. That said, I could not get the nuts onto the molded-in bolts on the back of the logo, since I have an EB with the shutters between the grill and radiator. After an hour and a half of struggling, I gave up and just epoxied it in there.That was only on the early ones that were made for the 11-14. He has since revised the post locations and they should pop right in.