Half shaft install

[rainmaker]

After you remove the axle nut, do you need to have a hub remover puller http://www.ebay.com/itm/New-Front-H...-D070-D93P-1175-B-Fast-Shipping-/261449605474

Looking at the Ford racing instructions, it talks about using a hub puller http://fordperformanceracingparts.com/download/instructionsheets/FordInstShtM-4130-M.pdf

?

Sponsored

 

[RBS550]

After you remove the axle nut, do you need to have a hub remover puller http://www.ebay.com/itm/New-Front-H...-D070-D93P-1175-B-Fast-Shipping-/261449605474

Looking at the Ford racing instructions, it talks about using a hub puller http://fordperformanceracingparts.com/download/instructionsheets/FordInstShtM-4130-M.pdf

?

I used a dead blow hammer..not a hard hit at all, mine came out super easy. Beefcake has a good write up on shaft install on this forum.

 

[rainmaker]

I used a dead blow hammer..not a hard hit at all, mine came out super easy. Beefcake has a good write up on shaft install on this forum.

Thanks - as soon as my Ford racing shafts get here I'm going to tackle this install and find somewhere local I can trust with an alignment. Then off to the track to see what the Vortech can do :cheers:

Sponsored