Front bumper cover removal

[Dmaster]

Does anyone know the procedure or a how to link for removing the front bumper cover on the 2020 GT500?

Sponsored

 

[MikeMM]

Please see the following. I think the admins need to make this a sticky.

 

[Dmaster]

Thank you so much. Can you post one for the rear bumper cover as well?

 

[protraxduner]

Other than the million screws holding the splitter and belly pan on its pretty simple. The 2 bolts holding the front bumper to the fender are kinda tricky but if you have battery powdered 1/4 ratchet its easy.

 

[MikeMM]

Thank you so much. Can you post one for the rear bumper cover as well?

Ask and you shall receive.

 

[Tomster]

Ask and you shall receive.

May I have an Anderson Composites carbon fiber hood and decklid?

 

[MikeMM]

May I have an Anderson Composites carbon fiber hood and decklid?

Good one Tom! If I could pass out carbon like some sort of vehicular-themed Oprah, I would lol. I unfortunately can’t, but maybe you can put it on Santa’s list

 

[AngelDeath]

Not to dredge up an old thread, but other than the screenshots, is there a pdf version of the front bumper removal floating around? Want to give it to the shop thats going to be taking it off and want them to follow along even though they have done s550s before.

 

[MikeMM]

Not to dredge up an old thread, but other than the screenshots, is there a pdf version of the front bumper removal floating around? Want to give it to the shop thats going to be taking it off and want them to follow along even though they have done s550s before.

Not that I know of, but I can get higher quality screenshots for you if you’d like.

 

[Tomster]

its the same as the GT350. The workshop manual is pretty clear on the process. Remove the belly pan, splitter, and then the fascia. Its a pain but not difficult.

 

[AngelDeath]

Not that I know of, but I can get higher quality screenshots for you if you’d like.

That would be great, not to put you on the spot but any chance that can happen before Monday 10am?

 

[AngelDeath]

its the same as the GT350. The workshop manual is pretty clear on the process. Remove the belly pan, splitter, and then the fascia. Its a pain but not difficult.

I need a link or to print it out as the shop I am taking it to on Monday I want them to have in case they dont so they take it off correctly.

 

[Tomster]

I need a link or to print it out as the shop I am taking it to on Monday I want them ti have inc ase they dont so they take it off correctly.

Pm me your email

 

[Tomster]

I'll just PM it to you.

Sponsored