Dressed up engine bays

[JohnBoyNC]

I found a few old threads, but nothing specific to completed dressed up/show car engine bay mods and wanted to give a place for you show car guys a place to show off you work. Mine is in the beginning stages and I was hoping to get some ideas.

Here is mine from a few months ago. I'll have to take a new pic and post later.

Sponsored

 

[GT 50]

Here's mine, its a work in progress so far.

 

[DoingOK]

I've since added a paint-matched radiator cover and fuse panel cover to the mix.

 

[Road Dog]

Here you go from St Petersburg, FL

 

[dbasql]

These are awesome guys!

 

[Khyber]

this is about all the "dressing up" i've done... the filter is now blue since I oiled the filter again, so the filter is blue too. just ignore that in this pic.

 

[Todd15Fastback]

 

[SINBUSTER007]

todd,
was the steeda brace painted that way from them or was it black? i was looking to get the k member and the IRS subframe brackets for underneath the car and powdercoating them before install...didnt know if that would affect how the product performed.

 

[JohnBoyNC]

I've since added a paint-matched radiator cover and fuse panel cover to the mix.

That pinstriping is awesome!! :clap2:

 

[MJS-P51]

Just started in on mine. Coolant tank cover should be here in a day to rid myself of that awful eyesore. Looking at powder coating the strut bar back with yellow inset beneath the GT plaque.

 

[Todd15Fastback]

todd,
was the steeda brace painted that way from them or was it black? i was looking to get the k member and the IRS subframe brackets for underneath the car and powdercoating them before install...didnt know if that would affect how the product performed.

Steeda sent me an unfinished STB which was ready for powdercoating. I sent it to my local powdercoater and they did my custom red for $25

If you send them off to get powdercoated, it won't impact their performance at all.

 

[Strokerswild]

Fabulous potato pic of mine after last weekend's CAI install, but you get the idea....

 

[908ssp]

Keeping it simple this time, black and silver with just a few anodized fittings.

 

[Need4SpeedMotors]

Here is a nice one featuring carbon fiber from our great friend Dennis [MENTION=16215]SC_Ruby[/MENTION], always looking spectacular!

 

[Todd15Fastback]

todd,
was the steeda brace painted that way from them or was it black? i was looking to get the k member and the IRS subframe brackets for underneath the car and powdercoating them before install...didnt know if that would affect how the product performed.

[MENTION=10567]SINBUSTER007[/MENTION]I got a bare STB from Steeda and sent it off to my local powdercoater for them to match the red on my coil covers.

The powdercoating they used on my can take temps up to 400 degrees so that is more than enough for under hood temps. No impacts on the product and how it performs either.

Sponsored