Does Anyone Make Poly Rear Spring Isolators for a Magneride Shocks??

[DougS550]

Hi. My 19 in just 2000 miles wore out my OEM rear magneride shock Isolators. I known its due to my locking veryting out on the rear and every shift or bump isntr cushioned by rubber mounts and so they just slam the isolators on each shift. Thanks

Sponsored

 

[NGOT8R]

Been there myself recently. Unfortunately, there are none available in polyurethane. I even reached out to Energy Suspension to see if they offered any and they said, NO. I ended up having to reorder factory isolators again. I used heat shrink on the ends of my coil springs, in hopes that it might slow down the tearing of the isolators, but tbh, it probably won’t help at all. Here are the part numbers for new top/bottom and left/right rear isolators.

DG9Z-5586-A

Upper Seat

$15.49

JR3Z-5586-A

Upper Insulator

$16.54

FR3Z-8321-A

Lower Spring Insulator

$24.81

E1GZ-8321-A

Lower Spring Insulator

$10.32

https://www.mustang6g.com/forums/conversations/your-new-bullitt.613522/

 

[NGOT8R]

I should add that you could try using Energy Suspension’s tube style isolators on the bottom and maybe add a flat poly isolator on top of the factory top isolator (sort of like Steeda aluminum spring spacer).

 

[shogun32]

in hopes that it might slow down the tearing of the isolators

I haven't looked at the dimensions. Would a Delrin 'bucket/endcap' work if sufficiently corner-rounded?

or grind the edges of the 'ground flat' portion so it's no longer "flat"?

Maybe this could work? Trim with hobby knife.
https://www.mcmaster.com/products/s...ene-rubber-sheets-and-strips/?s=rubber+strips

 

[NGOT8R]

I haven't looked at the dimensions. Would a Delrin 'bucket/endcap' work if sufficiently corner-rounded?

or grind the edges of the 'ground flat' portion so it's no longer "flat"?

Maybe this could work? Trim with hobby knife.
https://www.mcmaster.com/products/s...ene-rubber-sheets-and-strips/?s=rubber+strips

Maybe, but as you said, it would probably require a router of some sort to make roundover edges.

Sponsored