Ditched the 5.0 emblems...

[BlackGT]

I like your inspiration! Here is one that I let get away from me but the guy had enough money to ease the pain.

Sponsored

 

[CommyO]

Putting Boss emblems on a non boss is like a v6 putting on 5.0 badges...

 

[Falconetti]

Putting Boss emblems on a non boss is like a v6 putting on 5.0 badges...

We had a douche driving around here awhile back with an 88 T-Bird and Cobra emblems on the side...lmao.

Ahh crap it was me.

 

[bluebeastsrt]

Done to my taste.

And that's all that matters.:cheers:

 

[BAdrosky]

I think window louvers would be pretty sweet!

 

[jpilone]

I thought the Ford Racing badges were adhesive?
Steeda and CJ's advertises them as such, did you source others with pins from somewhere else?
Many thks
Phil

They were both adhesive with no pins. Just took my time to line them up right. I put masking tape on the bottom and rearward edges of the 5.0 emblems to help along the new badges.

 

[jpilone]

I like your inspiration! Here is one that I let get away from me but the guy had enough money to ease the pain.

That's a beaut!!!

 

[RobHunt]

Putting Boss emblems on a non boss is like a v6 putting on 5.0 badges...

No BOSS emblems here. The 302 is the displacement of the 5.0L

Like the "302" emblem but the "powered by" is not to my taste. Both cars look great!

 

[POJ 1]

They were both adhesive with no pins. Just took my time to line them up right. I put masking tape on the bottom and rearward edges of the 5.0 emblems to help along the new badges.

With the original 5.0 badge being adhesive, any problems /suggestions about removing them without damage to the paint surface underneath?
Thks
Phil

 

[ero 5.0]

With the original 5.0 badge being adhesive, any problems /suggestions about removing them without damage to the paint surface underneath?
Thks
Phil

The original 5.0 badges have two pins. There are two holes in the fender that are not in a straight line. One on lower left corner and one on upper right corner. Kinda sucks, cus the small 302 badge would look pretty good on the fender.

 

[POJ 1]

My mistake, I thought the factory badges were adhesive.
Anyway that simplifies their removal

Many thks
Phil

 

[jpilone]

My mistake, I thought the factory badges were adhesive.
Anyway that simplifies their removal

Many thks
Phil

The factory badges have alignment pins and adhesive tape to hold them secure. To remove them I used fishing line to "saw" the old ones off. When removed, I merely used my thumb to roll off the remaining tape and then wd-40 on a soft towel to remove the rest.

 

[DaUnit]

dude... get the 5.0 badges back on there real quick, asap...

 

[jpilone]

dude... get the 5.0 badges back on there real quick, asap...

 

[DaUnit]

dammit... :frusty:

Sponsored