Anthony@HTM
Well-Known Member
- Thread starter
- #1
This past Sunday my business partner and I fabricated a single exit exhaust for my car.
It bolts to the stock down pipe via a 2.25-3 inch reducer and then using pre mandrel bent piping we had it exit the passenger side of the car.
We made it completely out of T304 SS, back purged and tig welded. I am only using a single Borla straight through muffler.
In my opinion it sounds great and is pretty light. I'll try to weigh it next week versus the stock exhaust.
Absolutely no droan and quiet at idle.
This video shows cold start, there's a jack holding the exhaust up since the hangers were not done when I shot the video.
Overall I'm really happy!
[ame]
It bolts to the stock down pipe via a 2.25-3 inch reducer and then using pre mandrel bent piping we had it exit the passenger side of the car.
We made it completely out of T304 SS, back purged and tig welded. I am only using a single Borla straight through muffler.
In my opinion it sounds great and is pretty light. I'll try to weigh it next week versus the stock exhaust.
Absolutely no droan and quiet at idle.
This video shows cold start, there's a jack holding the exhaust up since the hangers were not done when I shot the video.
Overall I'm really happy!
[ame]
Sponsored
Last edited: