vincentjm
Well-Known Member
- Joined
- Mar 23, 2019
- Threads
- 41
- Messages
- 123
- Reaction score
- 32
- Location
- Switzerland
- First Name
- Vincent
- Vehicle(s)
- '15 Mustang GT PP
- Thread starter
- #1
Hi guys
I recently did a 2018 Manifold swap on my 2015.
Now, I did the full IMRC delete, so all of the holes in the Steeda CAI plastic elbow piping are unused. I stuffed these holes with some silicon, and while it does the job, it looks pretty ugly.
I thought about fabricating my own pipe out of aluminum, but I may need some advice.
The diameter where the MAF sensor sits is 101mm, but the throttle body opening is 2.5".
Would it be ok to just put a reducer coupler right after the MAF housing, and use 2.5" piping from there on?
Cheers
I recently did a 2018 Manifold swap on my 2015.
Now, I did the full IMRC delete, so all of the holes in the Steeda CAI plastic elbow piping are unused. I stuffed these holes with some silicon, and while it does the job, it looks pretty ugly.
I thought about fabricating my own pipe out of aluminum, but I may need some advice.
The diameter where the MAF sensor sits is 101mm, but the throttle body opening is 2.5".
Would it be ok to just put a reducer coupler right after the MAF housing, and use 2.5" piping from there on?
Cheers
Sponsored