CJ V2 monoblade TB

[Andygs550]

Hello everyone,
I’ve done some searching but can’t find anything regarding this subject.
I’m looking at the 1320junkie ported CJ v2. I’d like to go with a VMP 137mm monoblade TB. (Online says it’s for the 11-14 only) Has anyone ran this set up before on a second Gen? What is needed to make this a seemless installation, and has the tuner ( mine is PBD ) had any issues. I’m trying to build a NA 500+ Whp manual second gen coyote. Cams will be coming next after I figure out this manifold issue. My tuner recommended going with the VMP 67 mm TB. But I know the mono maximizes the power out put. Your suggestions and advice is greatly appreciated!

Sponsored

 

[KingKona]

Maximizing power output (peak HP) may not really be what you want. Does the VMP 67 mm TB do better under the peak with mid-range torque and HP?

Chasing a HP peak number is pretty silly, look at the entire power curve.

 

[Andygs550]

From what I’ve been reading power curve on the monoblade is higher all the way through to about 8200 rpm ( with opgs ) the mono allows more airflow that the twin.

Sponsored