Timemachine
Member
- Thread starter
- #1
Installed TSS OPG and timing sprocket, Whipple and Fore fuel system and PBD tune. Upon initial start up had CEL with camshaft position codes . Cleared codes and no lights on for the day of getting engine up to temp and test drives. Car sat for 2 days and on start up codes were there again, cleared and no CEL on for the day. At first I thought maybe I had installed chains off a tooth or 2 but no codes present for a timing related issues. Sensors are plugged in, no melted or pinched wires. My oil pressure seems to be higher than it was before the install at start up and when warmed up. My thinking is that I get a CEL on initial start up (higher oil pressure) and when oil temp comes up is I do not get a returning CEL like I would if timing was off? Any thoughts?
Sponsored
