Bob's catch can mounting

[LETHAL]

Anybody have placement issues with the Bob's Ultimate Oil catch can set up?

The suggested place on the pass strut tower ground flange just isn't working for me as there is an hard A/C line and the power distribution block harness below there on my car.

Love the quality of the product but the engineering seems a little off.

Any ideas?



I have a JLT currently but love the look of the AN fittings and braided line and would like to upgrade to the Bob's.

Sponsored

 

[Souldriver]

Yes, ended up having to sell it. If you call them theyll state they never heard of fitmant issues but on this forum there are at least 5 people ive seen have issues. It all could of been solved jf the bracket was 1 inch longer. The can would be out in the open then and easier to access.
http://www.mustang6g.com/forums/showthread.php?t=86097

 

[aham23]

the UPR version with the strut tower mount didnt work for me either. not enough room to "jam" it into that sport. currently have Bob's version sitting around to be installed. not happy to hear this.

 

[jdoug]

The front left corner is a good spot:

http://www.mustang6g.com/forums/showthread.php?t=15339&page=8

Sponsored