BMR Spring Install

[Ryan1112]

Check your sway bar end link nuts. I don't know the torque spec but they need to be really tight.

Sponsored

 

[Cascadia_302]

Everything is put back together and now there is a clunk at low speeds when going over a bump or turning. I double checked the upper strut mounts and they are torqued properly. I made sure to torque everything down when installing. This spring install has been the death of me.

Did you trim your bump stops?

 

[shelbydave]

Did you trim your bump stops?

That shouldn't cause a clunk. It would create a harsh stiffness over bumps

 

[Cascadia_302]

I know it takes alot to hit them, just curious.

 

[scoggy_doogan]

Thanks again guys. It was the nut on top of the strut. I had a hard time torquing it down without spinning, but managed to jerry rig it and get it done.

Seriously you guys rock. I love this forum. :hail:

 

[shelbydave]

Go through and double check the six nuts on top first..there the easiest.then go from there

 

[shelbydave]

Thanks again guys. It was the nut on top of the strut. I had a hard time torquing it down without spinning, but managed to jerry rig it and get it done.

Seriously you guys rock. I love this forum. :hail:

Awesome!!
Glade you got it squared.

 

[Cascadia_302]

Thanks again guys. It was the nut on top of the strut. I had a hard time torquing it down without spinning, but managed to jerry rig it and get it done.

Seriously you guys rock. I love this forum. :hail:

That'll only cost you two beer's.:cheers:

 

[Ryan1112]

Glad you got it figured out.

Sponsored