strengthrehab
Well-Known Member
- Thread starter
- #1
In preparation for next season, I'm going to tackle some aero mods in the next couple of months. Plan is for a splitter out of 1/2" birch plywood and a spoiler out of Lexan both of which will meet CAMC rules.
The splitter will be removable for street driving and I'm going to get a different decklid for the spoiler. I contempleted the ZL1 Addons wicker bill for the GT500 swing that I have, but not sure it will fit within the rules.
I'm also contemplating trackspec GT4 vent kit for the hood too.
Anyone who has done this,,,where did you source your splitter rods?
Should I just use some cardboard for the form of the spoiler first?
Can I use a trunk lid that has OEM spoiler holes or should I use a non-spoiler one?
Any other tips?
The splitter will be removable for street driving and I'm going to get a different decklid for the spoiler. I contempleted the ZL1 Addons wicker bill for the GT500 swing that I have, but not sure it will fit within the rules.
I'm also contemplating trackspec GT4 vent kit for the hood too.
Anyone who has done this,,,where did you source your splitter rods?
Should I just use some cardboard for the form of the spoiler first?
Can I use a trunk lid that has OEM spoiler holes or should I use a non-spoiler one?
Any other tips?
Sponsored