11secls1
Well-Known Member
- Joined
- Sep 21, 2015
- Threads
- 26
- Messages
- 179
- Reaction score
- 80
- Location
- Weatherford TX
- Website
- www.axxis-corp.com
- Vehicle(s)
- 2018 Mustang GT A10
- Thread starter
- #1
Figured it was about time to create a build thread for the GT350. The car is a Comp Orange 2016 Shelby GT350 with standard features. After putting a few miles on the car, it was immediately obvious that stock was just not good enough. Next step was a set of ARH 1 7/8” headers and off-road X-pipe. That netted 505 RWHP on a chassis dyno and an 8.0 1/8-mile time slip.
The car is currently getting CNC ported heads and custom cams from Frankenstein Engine Dynamics.
https://www.facebook.com/FrankensteinEngineDynamicsLLC/
After that we will be doing twins and a billet intake manifold:
Here are a few pics of the current build.
Before teardown in the back there hiding:
Under the knife:
Creating the new port(s) profile:
The car is currently getting CNC ported heads and custom cams from Frankenstein Engine Dynamics.
https://www.facebook.com/FrankensteinEngineDynamicsLLC/
After that we will be doing twins and a billet intake manifold:
Here are a few pics of the current build.
Before teardown in the back there hiding:
Under the knife:
Creating the new port(s) profile:
Sponsored
Last edited:
