BlackBoostedStang
Well-Known Member
- Thread starter
- #1
Hey everyone,
I want to share my experience installing my Mantic Series 9000 Cerametallic Clutch. Overall, the install was not as difficult as I expected it to be. Going in I felt I should have a professional install this twin disk unit. However, I came to find that the install was pretty easy!
This was my first time dropping a transmission and the first clutch install I ever did too. The directions from Mantic are pretty straight forward. Everything for the install comes with the kit: Flywheel (with bolts) New Slave, Clutch Assembly, Pressure plate, etc.. Following their torque specs for the install it all went in pretty fast! I would recommend sourcing a torque wrench that measures in Newton Meters for the pressure plate install.
Check out the video below that shows the steps we took to install the Mantic Clutch!
[ame]
I want to share my experience installing my Mantic Series 9000 Cerametallic Clutch. Overall, the install was not as difficult as I expected it to be. Going in I felt I should have a professional install this twin disk unit. However, I came to find that the install was pretty easy!
This was my first time dropping a transmission and the first clutch install I ever did too. The directions from Mantic are pretty straight forward. Everything for the install comes with the kit: Flywheel (with bolts) New Slave, Clutch Assembly, Pressure plate, etc.. Following their torque specs for the install it all went in pretty fast! I would recommend sourcing a torque wrench that measures in Newton Meters for the pressure plate install.
Check out the video below that shows the steps we took to install the Mantic Clutch!
[ame]
Sponsored