Can anyone tell me what this diver colored cylinder is that is on the left side of the radiator? I pulled the air box to do GT 500 cam cover and water pump install. I had never noticed it before.
I have now had my car have the clutch pedal drop to about 1” from the floor twice. Both times at the dealership when they pulled the car up for me to pick up. First time I just pumped it once or twice and it came back to normal. The last time I called the Service Writer over to see it and after...
While on a road trip all of a sudden had a plastic tapping sound start on the passenger side behind glove box area. Pulled off highway and did visual in battery box area under hood. No obvious problem. Needed to get to destination so decided to let it self diagnose. A week or two later I found a...
Just watched his latest video on YouTube about his EcoBoost and he mentioned that he had joined the forum. Been a fan of his for almost a year now. Check him out and subscribe to his YouTube channel. David Vizard
Ok, so I ordered the Harrop oil cooler yesterday from Beefcake. I am looking for installation tips and tricks to make this a great experience. Will be doing the work myself.
Also, very interested in any suggestions on ducting to improve cooling and efficiency. I am familiar with fabrication but...
W/ Black tips Have been on the car for about 20K. Replaced with a Solo Performance system because these with a FP X-Pipe were too loud and droned. These would work fine with a stock resonator. I prefer to sell locally in Norcal.
OK, going to do my first HPDE event this spring. After studying this and other forums I have accepted the advice that the stock Brembo's on the car will suffice and that the part that has the room for the most improvement and upgrading will be me. With that said are there any other things that I...
I am preparing to do a once over in preparation for my first HPDE. Car has 63K miles on it. On my list of "to do's" is coolant change. Is the FP water pump a worthwhile change at this time? Should I change coolant hoses (OE are currently on)? I plan on changing belt(s). Is there a preferred...
I am going to be installing a 3" cat back system. I intend to wrap the areas near the trans and diff. I have a few questions for those of you who have wrapped your system in one or both of these areas. I have one package of DEI wrap which I believe is two 50'pieces.
1.) Am I correct that I have...
I had not driven the car for nearly two weeks, and it had been parked outside. Had backed it into the driveway so the front end was lower than the back due to the slope of the DW. We had a pretty good storm come through and over a day and a half or so it dropped nearly two inches. I have the...
I am looking to take the edge off of the system that I have now. I believe that I have found the mufflers that I want, but they are sold in a kit with an x-pipe and intermediate pipes. I already have that and only need the mufflers. It is Ford Performance
CAT BACK TOURING EXHAUST SYSTEM -...
Well, I put an X-Pipe and Kooks axle backs ( SKU: 11516210) on my car quite a while back. Liked it then, but it is just too loud, and the drone is too much for me now. I like the sound of an x-pipe and want black tips. I know that many run stock mufflers with an X, but I prefer not to modify the...
I purchased a used set of 19X10" wheels and want to ask how you all are removing the balancing weights and the sticky glue that adheres them to the wheel without damaging the finish on the wheels? My initial thought is to use Goo-Gone after prying them off of the wheel. But I wanted to know if...
I have the FP PP2 installed on my car and have never been impressed with IAT since install. After noodling here and other places in the interweb I decided to make a few mods to it to see if I could lower IAT. Since the GT 350 airbox did not seal on the bottom of my hood and I was sure that was...
Planning on doing some HPDE next year. Will be staying with MPS4S since the car is primarily a DD.
Has anyone run on both sizes with 19X10's? So far, I am leaning toward the 285/35 as the 295 appears to be just a tad wide for a 10" wheel and I suspect will have too much sidewall flex and roll...
Has anyone tried MPS4S 265/40ZR19 on the front and 285/35ZR19 on the rear of 2017 GT PP car?
This is one size up from factory size and would add 1 inch in width front and rear. It also adds 1/32" tread depth when new. Also adds 0.2" overall diameter on fronts and lose 0.2" in rear.
I am...
I have tried to reset the accelerometer to zero by holding the OK button. No Bueno
Have tried to going to set and clear all. No Bueno.
Any other suggestions?