Search results

I bought a whiipple 3.0 for 2018-21 I have a 2015. I have iat extender and everything else looks good. Just don’t know what to do with imrc. Do I just cut and make new connections?

Basically, it says the right-side front and rear are 3 psi. I have new tps sensors oem Ford. I have tried FOrscan reset, factory reset brake ignition 3 times brake ignition 3 times. I have drove car and it does not go into a reset. Had at a shop they could not reset either. Any ideas. Running...

Need real expertise on ABS light. 2015 30k miles Light comes on immediately which means it’s an electrical issue not a sensor or rear hub problem. New front speed sensors Both rear hubs are brand new ABS module is new All fuses checked All relays checked Reset all with FORScan several times I...

Need real expertise on ABS light. 2015 30k miles Light comes on immediately which means it’s an electrical issue not a sensor or rear hub problem. New front speed sensors Both rear hubs are brand new ABS module is new All fuses checked All relays checked Reset all with FORScan several times I...

2015 GT 30k miles. I have been fighting this issue for about a year now. I replaced both front speed sensors, both rear axle hubs and replaced the ABS module. Checked and replaced the fuses and relays. I am sure its electrical somewhere, but I need help on where to begin. Note when I replaced...

Dunno what’s causing the light. I went ahead and replaced both front abs sensors and still on. Will FORScan tell me and how to do it. Thanks

Need help on how to diagnose these codes. Maf sensor replaced with oem Speed sensor also replaced oem 2015 GT 29k miles Car seems to run ok. Not running in limp mode. Fresh 93 octane 5 gallons( but 2 year old gas about 3 gallons was in car before refill) Smoke test performed no leaks New plugs

How do I check to see if my maf is bad?

Has anyone had trouble data logging with vcm. I can’t get it too work.

I am willing to Venmo someone if they can help work through some issues. So I bought the car 2 years ago totaled. I have replaced everything and it’s painted and running. I did cams, cai, 2018 intake lock outs and exhaust. Lund gave me a running tune for it. The problem is I am getting a ton of...

Major valve ticking. Most times I will start it up and it will not go away. Then other times I will start it up and it will tick and then the engine will surge then the tick goes away. I pulled valve cover and found a cap was loose, so I tightened it up and it still ticks. It only om the left...

Left side rocker tick loud after fist start then goes away? This just started anyone know why?

Engine was out. Ran before removing. It will start rev to about 1800 then dies. If you touch gas pedal it immediately dies. Mods are stage 3 comp cams, full exhaust and pmas cai.

Need a clutch pedal assembly

Need a clutch pedal assembly

2015 GT putting it back together. I lost all the pics I had of disassemble. Need to know what these plugs are for back of engine and how is the vacuum for brake reservoir ran?

Motor is out and need to move the drivers seat. I know there are the 3 connectors looks like 2 are 12v and the center is ground looks like? I connected the 2 to 12v and center one to ground and nada. So that is why I am asking. Thanks for the input

WTB gauge tuner 2015 cams, exhaust, intake cai

WTB unmarried gauge 2015 w/ cams, intake, exhaust & cai

Need help with location. Engine bay close ups would be great. There is a connect next to brake booster I’m not sure what goes there. Any pics would be helpful