Search results

No issues. The struts went in just as any other strut install. Took about an hour each side for the struts. And maybe half an hour each for the rears accounting for boring out the top bracket hole.

So I just finished installing my struts. Need an alignment before I hit them hard and I want to give them a little time to settle in, but they feel great. As of now I have the full set of koni on and I am running vogtland 1" drop progressive springs. I have front and rear set right in the...

I was thinking about getting the Vikings while I waited on the Koni. They should pair well. I am assuming you could set the compression valving to match the Koni. On the other side... The rears aren't that bad of an install. The second rear I did went much faster since I know what I needed to...

Yes. You will reuse the other hardware and they provide 2 nuts and a spacer for the top. I wasn't exactly sure which side the spacer goes on but I put it under the top mount to provide a bit more bearing area for the loads. Then up top I tightened down one of the nuts then the second on top of...

Thanks Todd. So the second one went much smoother. Got the top mount drilled out and in in less than an hour. Looks like the have about a 2.5 turn adjustment. I set them right in the middle and went for a little test drive. They feel very similar to the performance package at the middle of...

I had to ream out the hole in my rear top mount for the threads to fit through. Only managed to get one on in about 2 hours. I will post pictures whenever I get Tapatalk to work. Not sure if my mounts are just a tighter fit, but I couldn't see how this would get past all the testing. A...

Rear top mount won't fit Looks like the top mount will need some modification.

BMR Vertical links and toe rods so far. Sent from my iPhone using Tapatalk

I've tried a couple wheel cleaners. I'll try wd40 Sent from my iPhone using Tapatalk

Killer Sent from my iPhone using Tapatalk

Any tips on cleaning brembo calipers. I can't get these water spots off Sent from my iPhone using Tapatalk

Gt pp 19s Sent from my iPhone using Tapatalk

I have a pp car with the above installed Perfect height Sent from my iPhone using Tapatalk

Yes I do have you on the list. I am trying to get all the shipping stuff figured out. Also looks like another order will be needed. If anyone has any other suggestions. I will probably order a few 22# that I found as well as the 39 and 59 Sent from my iPhone using Tapatalk

Correct. If you are willing to pay that much. I can get you a similar spring rate under half that price and I just lightly sanded with high grit sandpaper. Sent from my iPhone using Tapatalk

Looks like all of the springs I ordered are accounted for and some of the more recent PMs won't make it to this order. I am planning on putting in another order and adding an ultralight spring option at 22 pounds, but slight modification is required. Fine sanding the center shaft. I will post a...

I ordered 7 39 and 3 59 as I assumed the 39 would be most popular. I have received some PMs and looks like I will need to put in a second order. Wanted to check in on everything before shipping anything. Sent from my iPhone using Tapatalk

Heard there are adjusters for the steering but I can't find it now. Sent from my iPhone using Tapatalk

Idk. I felt them just compressing by hand and there is a difference Sent from my iPhone using Tapatalk

To all. Yes the 39# is a tight fit. I hit my assembly with a little bit of high grit sandpaper. Sent from my iPhone using Tapatalk