2015-17 Mustang GT Ford Performance Power Packs

[accel]

good job. I haven't read all 300+ pages of this thread but I recommend buying a AFM extension harness if not already suggested. The stock harness was pulled real taut, this gives a lot of extra slack and peace of mind. Found an example online

Not sure this is needed for pp2. All wires reconnect nicely.

Might be a thing for pp3.

Sponsored

 

[muscandy999]

Not sure this is needed for pp2. All wires reconnect nicely.

Might be a thing for pp3.

Thanks

 

[MagneticMan]

not needed but puts less stress on the factory harness and allows for neater rerouting. The factory harness as I recall had to be unclipped to give it just enough slack to connect to the MAF. For $20 it was worth it to me. Just a tweak.

with and without:

 

[muscandy999]

Hello everyone, where can I buy this adapter?

 

[PSI]

Hello everyone, where can I buy this adapter?

I’m fairly certain that is molded into the intake tube and cannot be bought separately. If yours broke you may be able to find a similar fitting and somehow rig it up.

 

[phatsesh]

I use superglue and heat shrink

 

[accel]

Hello everyone, where can I buy this adapter?

i bought a complete replacement used intake

 

[muscandy999]

Hello everyone. Thank you very much for the advice. I bought pp2 and installed it today. Everything went well. I didn't cut the valve cover, I bought an adapter and I managed to install it. The car has definitely changed. Soon I will install the rear gearbox 3.55

 

[paul73]

Does anyone live in the Las Vegas area and have a procal3 cable I can borrow or buy?

 

[accel]

Does anyone live in the Las Vegas area and have a procal3 cable I can borrow or buy?

I do not live in Las Vegas, but since I have PP1 and PP2 I wonder if one of the procal cables I have is redundant.

 

[accel]

i bought a complete replacement used intake

BTW, just in case. The air intake elbow is different for 2015-2016 and the rest. So if one shops for a replacement - be careful and check pictures. They have a different number of outlets. So check pictures before you buy one.

 

[G.T.]

Hello everyone. Thank you very much for the advice. I bought pp2 and installed it today. Everything went well. I didn't cut the valve cover, I bought an adapter and I managed to install it. The car has definitely changed. Soon I will install the rear gearbox 3.55

Nice!

How did you get the software? Is your car a USA market vehicle?

 

[muscandy999]

Nice!

How did you get the software? Is your car a USA market vehicle?

No, I'm from Kazakhstan. I ordered, bought, installed everything,

 

[G.T.]

@muscandy999 , how did you order yours? I want one too but they always state software available for US Market vehicles only.

What did you do to get the tune and load it to your car?

 

[accel]

No, I'm from Kazakhstan. I ordered, bought, installed everything,

How do you like your setup versus OEM?

Did you test your setup against detonation? Windows down, some obstacle to your left or right like a fence or concrete wall, basically something that reflects the sound back to your ears.. Accelerate and push your gas pedal down especially around 2500-3500 rpms. If it is there you'll hear it.

I wish you do not have it, but it is better to know whether you have it or not.

Sponsored