Recent content by scoggy_doogan

Exactly what I needed to hear! Thanks!

Alrighty, I'll definitely call them in the morning!

My dealer ordered my 2023 mustang today and I decided to go with the spoiler delete, but on the order sheet from DORA, it shows "blade decklid spoiler" as an option. Do I need to call my dealer and make sure the spoiler delete was input correctly?

I switched out to the Steeda spring. But now I think I probably lifted just a hair. I'll have to give it another try fully committed. Thanks!

I've been running the power pack 2 on my 2016 for a week now. I love the extra pull and higher redline. It really changed the car for the better. That said, I don't think the no lift shift is working on my car. I went to test it by shifting at 5500 rpm from 3-4, kept on the gas and pushed in...

Thanks! That's what I figured I would do, but just wanted to make sure I wasn't missing something.

I know this is a piece of cake to install, but my FRPP oil separator doesn't have the little hole in the bracket to put the wiring harness clip back into. Do I just leave it unclipped?

Has anyone else's trunk leaked? I opened mine after it rained all day and I found about 3 large puddles in my weathertech mat. It's dripping from the driver's side, close to the side carpet. I had no luck trying to trace it back to where it is entering.

So I've been stuck trying to figure how a 255/40/19 on a 19x9.5 would look. I know most on here are going to say it is way too stretched, but I have always liked a slight stretch look. I found a site that has over 2000 user submitted setups and you can search for a wheel size/width and tire...

I was running MRR M350 wheels at 19x10 for a year and a half, but got t-boned on the passenger a pillar and have had rubbing issues with 19x10 up front since then, even with 3 mm spacers. I was looking at 19x9 square with tsw bathurst or geneva but just couldn't justify the extra grand for...

Bmac, amazing build. You convinced me to go ahead and get a set of SVE drifts for my car.

It doesn't do it any more. Not sure which update fixed it, sorry.

The FR3Z-19850 is the entire evaporator assembly. The FR3Z-19860 is just the core itself. Ford used to replace the entire assembly and now just replace the core. I'm guessing it's due to cost since the core is about 1/3 the price of the entire assembly. Saves Ford money on warranty claims.

Ya the part has a 1 year warranty, but that is all that is covered if it fails again within that time. Labor is almost never included in the part warranty, so the total replacement cost will be $1400 instead of $1700.

Edit: I had the dumb, part FR3Z-19860 is the core, FR3Z-19850 is the entire assembly