OrangCrush
Well-Known Member
Currently in the process. Just have to drill holes. Will the sides come in with the two studs in each side?
Sponsored
Currently in the process. Just have to drill holes. Will the sides come in with the two studs in each side?
Going to attempt this weekend. Will the dremel 100 series do the job?
Anyone?
I just answered your PM. :cheers:Where did you start cutting? Do you cut below the lip?
Post up some pics. I have a gap on one side. I also had sh!ty 3M tape from AutoZone.Well I am done with bumper. I have little gaps where the winglets slide into valance. I didn't want to cut too much off. Now I have to install the quad tip exhaust. What 3M tape did y'all use because the one I bought sucks?
Looks Killer!Well I am finished
Do you have pics of the rear bumper but left or right side ?Well I am finished
I am struggling to get that gap closed as well. Any help greatly appreciatedAny tips on how to close the gap
Looks incredible. Fantastic job, man!Well I am finished
Bryan,Does any one know if this can be done with either the Anderson Composites or Ikon motorsports gt350 valence?