Is there seriously no engine cover options for a Gen3 Coyote? ...

[Biggus Dickus]

Like she arrived with too much 70's bush

There's no such thing as too much 70s bush.

Here's my engine cover:

Sponsored

 

[ice445]

I took it off, I think it looks better with the "rats nest". But I also don't want heat being trapped underneath it in the molten summer temps.

 

[Scooter MGee]

Dressed up......dressed down......you decide.

 

[MX5Racer]

Nobody looks under the hood any more, unless they have a reason to be there. You aren't going to impress anyone with a pretty plastic engine cover and a K&N air filter.

As a photographer, the hoods up at car shows always bugged me anyways. Ruins the beauty of the car, and usually there was nothing special under the hood.

 

[theruleslawyer]

As a photographer, the hoods up at car shows always bugged me anyways. Ruins the beauty of the car, and usually there was nothing special under the hood.

Kinda like those spread eagle shots errr…..elsewhere.

 

[mrpicolas]

Dressed up......dressed down......you decide.

did you cut the wings off the cover or is this available anywhere to buy?? this imo looks better than the Enterprise that we all have

 

[Scooter MGee]

did you cut the wings off the cover or is this available anywhere to buy?? this imo looks better than the Enterprise that we all have

I did trim down the original. It was pretty easy using a Dremel. Less than 5 minutes of work.

 

[Chef jpd]

Take off the cover, turn it upside down and the parts seperate after cutting the plastic rivets:

20201021_144845 by chefjpd, on Flickr

20201021_144836 by chefjpd, on Flickr

 

[ZeroTX]

Nobody looks under the hood any more, unless they have a reason to be there. You aren't going to impress anyone with a pretty plastic engine cover and a K&N air filter.

Not looking to win any car shows, but it's typical at car meets to pop the hood, even on a stocker.

 

[mrpicolas]

Take off the cover, turn it upside down and the parts seperate after cutting the plastic rivets:

20201021_144845 by chefjpd, on Flickr

20201021_144836 by chefjpd, on Flickr

Thanks man looks like ill be doing this soon.

 

[ZeroTX]

Dressed up......dressed down......you decide.

I like it. Where to get the fuel rail covers and what are the steps to cut down the cover to keep the center portion?

 

[Scooter MGee]

I like it. Where to get the fuel rail covers and what are the steps to cut down the cover to keep the center portion?

Part number for the fuel rail cover kit is M-9680-M50BA. Available from your vendor of choice.

I don't recall a step by step but its very self explanatory once you start looking at the underside of the engine cover. Dremel and a plastic cut off wheel is what I used.

 

[ZeroTX]

Part number for the fuel rail cover kit is M-9680-M50BA. Available from your vendor of choice.

I don't recall a step by step but its very self explanatory once you start looking at the underside of the engine cover. Dremel and a plastic cut off wheel is what I used.

Next question: I see this kit contains both covers and hoses? Why are hoses being replaced?

 

[Scooter MGee]

Next question: I see this kit contains both covers and hoses? Why are hoses being replaced?

I'm not even sure. I did not use them.

 

[ZeroTX]

I'm not even sure. I did not use them.

Sucks because I'm sure that's the majority of the price on that "kit." I just want the plastic pieces, then. Hrmph.

Sponsored