Bullitt Mod Recommendations?

[number 6]

Good to hear; thanks. I have a jeweler's screwdriver set somewhere in the garage, so will look for it. Not sure if I'll try that, since I want to remove the wheels anyway to clean and put the Turtle Wax ceramic spray coating I have, to see if it helps with the dust not getting stuck.

JC, I was concerned about the pop-out method also, but when I tried one, it popped out so easy it surprised me. I used one of those small red Swiss Army pen knives. One of the blades has something that resembles a fingernail file with a flat end tip, I just used that, easy peasy.

Sponsored

 

[Elp_jc]

Good tip. I tried a jeweler's screwdriver yesterday, and no luck. Didn't want to try any harder, or would have pierced the tape, and scratch the cap (I WILL reuse them. Ha ha). I have a Leatherman Wave tool somewhere, so will look for it, and check if it has an 'appendage' like what you described . Thanks brother.

 

[number 6]

Good tip. I tried a jeweler's screwdriver yesterday, and no luck. Didn't want to try any harder, or would have pierced the tape, and scratch the cap (I WILL reuse them. Ha ha). I have a Leatherman Wave tool somewhere, so will look for it, and check if it has an 'appendage' like what you described . Thanks brother.

JC.. here are some pics to help you along.
I just wrapped it in the blue mask, and popped it out, no scratches on either cap or wheel.

UPDATE... the cap in the pic does have an abrasion because that was the first one I tried without the mask wrap. The other 3 with the mask wrap, don't have abrasions.
But I don't plan on using the original caps for anything.
No abrasions on my wheels, even the first didn't mark it up.

 

[Voo Doo]

So far I have
-Ford performance air filter
-oil catch can
-1 inch wheel spacers in the rear+rokblokz mudguards in the rear
-DHG hurst Quarter window louvers
-custom steering wheel
-custom shift knob on the way
-gorilla locking lug nuts
-5spurs bullitt crosshairs starter button
-center nav system carbon fiber overlay
-DHG rtr hood vents

Does anyone have any recommendations for mods? I want to wait till after the warranty is up till I lower and tune the car. I was thinking getting a pedal commander but still thinking about it. Any recommendations welcome.

What custom shift knob...tell me not Anarchy Automotive??

 

[AnthonyA1234]

What custom shift knob...tell me not Anarchy Automotive??

Yea it is I just saw your post too that sucks. He told me I should have it in a week (I’ve been waiting for 7 weeks already). I’ll keep you posted what happens.

 

[zack.whitford]

Can you post some sound clips of the h pipe?

Here you go:

(This was in Track mode)

Sponsored