jmeiers
Well-Known Member
- Joined
- Oct 27, 2018
- Threads
- 41
- Messages
- 606
- Reaction score
- 347
- Location
- Northern Virginia
- Vehicle(s)
- 2019 Mustang GT PP1/401A/A10
- Vehicle Showcase
- 1
- Thread starter
- #1
Just received my shipment of Kooks catless longtubes (Black Friday) and planning out my garage install during the Xmas break. I've been watching lots of videos on it but there is not much info on the best place to jack up the motor, especially on a 10r80 car. Lot's of conflicting info on the forums too. I seen a vid showing a wide 2x4 on the composite oil pan and there were no issues. I don't have or want to buy an engine lift to support it from above so jacking up from below is the way I want to go.
I know plenty of people in here have installed their own longtubes on a 10r80 car. Where did you jack the motor up?
Thanks.
I know plenty of people in here have installed their own longtubes on a 10r80 car. Where did you jack the motor up?
Thanks.
Sponsored