What did you do to your S550 Mustang today?!

[EvilleGT]

This

Man, that's what I need to do. I tried mine with the pedal in the car. Got the clutch and brake pedal on no problem but the gas was a PITA.

Sponsored

 

[BFord1]

Looks great. I'll be adding one within the next few weeks. How did you install it without removing the fender liner? Did you just loosen it to reach the bolts behind it?

Once you remove the belly pan there's tons of access as long as you can get under there. Removing the fender liners wouldn't allow me to get to the fasteners in the middle without also taking the wheels off. If you can get up under there either on a lift, ramps or like I did you can get to everything you need once the belly pan is out of the way. You may have to loosen the very bottom of the fender liner to get to the bolts on each corner. This is how I'm going to change my blower oil and access my air filter from now on.

 

[BFord1]

Installed this fuel door and front chin spoiler

Looks bad ass with that splitter.

 

[Chef jpd]

 

[16EcomustangDIB]

Man, that's what I need to do. I tried mine with the pedal in the car. Got the clutch and brake pedal on no problem but the gas was a PITA.

Yeah, I could imagine. I wasn't going to even try doing the accelerator pedal while installed, and plus I also replaced my pedal height washer stack up with the actual spacers at the same time anyway.

 

[16EcomustangDIB]

Looks great, now screaming for a dead pedal cover to match.

You're right. I'll see what I can come up with at work.

Now how about this?

 

[Sawyerjames]

Looks bad ass with that splitter.

I appreciate it. I went out on a limb because it’s the new one from MMD that they market it as being compatible with the base model splash guard. Long story short after install you can’t re-install like 3 or 4 screws on each side for the splash guard so I’m assuming you need the one for the PP. everything is tight though so it’s not going anywhere...

 

[Dusten]

Swapped steering wheels. Pictures suck. Ok wait till it's day light to get better ones.

 

[dogiebitt]

Tinted the rear end of the car with a kit from Anchor Room. Smooth process and great results.

 

[AnalogDan]

Blank decklid panel, GT350 track pack spoiler, and an OEM active exhaust (still working on the FORSCan stuff).

Before:

After:

 

[Ghost50]

Tinted the rear end of the car with a kit from Anchor Room. Smooth process and great results.

How long did it take you?

I’ve got their kit waiting to install and debating on trying it myself or paying my tint guy to do it. I have a heat gun and squeege.

One other question; what mix of soap/water did you use?

 

[RACHI34]

I bought it!
2019 401a PP1 GT with A10!

Picking my 2019 PP1 LFP 800 on Saturday. Cannot wait!

 

[Ecoboosted]

I bought it!
2019 401a PP1 GT with A10!

First post I see. Congrats on your new Mustang!

 

[Nagare]

Put my MPT tune on the car finally, feels good so far but going to datalog and send it back to them to see if there's anything more they can get out of it before switching to 93.

Sponsored