Andy13186
Well-Known Member
- Thread starter
- #1
I had a bad cold start tapping as you can see in this video around 1 min in :
I added half a bottle of ceratec and I did notice some improvement immediately. Drove it for a couple hundred miles with no bad effects so I added the rest of the ceratec. You can notice there is basically 0 of the tapping at idle now.. pretty big difference but I still have a weird rattle noise on light revs that does lesson when the engine is hot. Anyone know what this is?
Go to 1 minute in in both videos for a direct before/after ceratec comparison, both are cold starts, same oil, only difference is the ceratec. If anyone knows what the light rev rattle is, let me know. Also let me know what you guys think. I talked about some stuff in the 2nd video, also did a dragmode run at the end.
One more thing I noticed after adding ceratec was improved gas milage.
I added half a bottle of ceratec and I did notice some improvement immediately. Drove it for a couple hundred miles with no bad effects so I added the rest of the ceratec. You can notice there is basically 0 of the tapping at idle now.. pretty big difference but I still have a weird rattle noise on light revs that does lesson when the engine is hot. Anyone know what this is?
Go to 1 minute in in both videos for a direct before/after ceratec comparison, both are cold starts, same oil, only difference is the ceratec. If anyone knows what the light rev rattle is, let me know. Also let me know what you guys think. I talked about some stuff in the 2nd video, also did a dragmode run at the end.
One more thing I noticed after adding ceratec was improved gas milage.
Sponsored
Last edited: