What did you do to your S550 Mustang today?!

[JOKER M1]

Polished Sealed & Waxed over the weekend

Sponsored

 

[z06psi]

I'm not trying to make it a Rolls, I just wanted to see if I could quiet down the drone a little bit and maybe scrub some road noise. These indy 500s are surprisingly loud.

I have the Magnaflow offroad quad tip with longtubes and no cats. Sound deadening the entire car made such a difference I don't want to get rid of my exhaust now.

;)

 

[Sig556]

Great job! You do good work.

 

[Chef jpd]

Installed a new battery. 745 cca

20180311_132034 by chefjpd, on Flickr

 

[Lost]

Installed a new battery. 745 cca

20180311_132034 by chefjpd, on Flickr

Why?

 

[Chef jpd]

Original battery crapped out, and I didn't want a replacement from Ford.

 

[Houston Kid]

I installed Steeda progressive springs, Steeda Pro-Action rear shocks and front struts. Lowered the car about 1". Installed Steeda aluminium upper rear shock mounts.

Stop the hop kit and exhaust are still OTW.

I think the sun and shadows are playing tricks with the wheel well clearance. The last pic better shows the actual clearance.

 

[16Fastback]

Started up he engine added some small mods I've had a little while.
Wade floor mats (a lot cheaper than Weather tech) seat belt pads and door stop covers.

 

[Donyw]

Installed Barton 2 post shift bracket and swapped the transmission fluid with Royal Purple Synchromax. Shifts a bit smoother. Definitely tighter. The bracket was a b**** to install laying on my back under jack stands in the 35 degree NY heat.

 

[JOKER M1]

Started up he engine added some small mods I've had a little while.
Wade floor mats (a lot cheaper than Weather tech) seat belt pads and door stop covers.

Nice, I need to get those covers

 

[16Fastback]

Side splitters and side scoops installed this weekend. I have black pony emblem to install but not as easy as I thought to install. Plastic under hood latch blocking access and can’t fit hand even loosening radiator supports. Not feeling like pulling bumper off to install right now.

I got a set in Ruby red can't wait till warmer weather to get them on.

 

[dogiebitt]

Get some of this cutting tape. Works great. You lay it out where you will want to cut the vinly then pull the tape to make the cuts. Perfect for rounded edges and curves where using a razor blade will be difficult. There are numerous YouTube videos how to use it.

https://www.walmart.com/ip/WrapCut-...4493&wl11=online&wl12=506187120&wl13=&veh=sem

I did use a knifeless tape in the side seams of the roof because I was trying to get the cut right down the middle of the seam, however while dealing with the bubbles I had to lift and re-position the vinyl a few times, which pulled up and displaced the tape. When I redo the wrap, I will mask off the entire painted surface between the door glass and the seam so that the vinyl doesn't stick there when I am laying it out.

 

[tj@steeda]

Added a Q-Series front fascia to a Steeda Performance Vehicle!

Here's another sneak peek at the new 2018 Steeda Mustang Front Fascia - let us know what you think!

:cheers:

 

[control4userguy]

16Fastback- seatbelt cover source? Those are much nicer than typical!

Sponsored