BMR SUSPENSION'S S550 Lowering Springs: STANCE PICS!

[08StangGT_CS]

It'll handle like crap with that stagger. Not trying to be antagonistic. If you aren't concerned about that, I get it. Be forewarned: that wide of tire is extremely prone to hydroplaning, particularly if you go with an NT05R or similar. Jeff Ashton had the same setup on his old Whipple'd GT and put it in a barrier without even trying to deploy the power. A 315 rear would be a good option for that wheel.

Thanks. I'll actually look into these when I get a chance. I'm looking at MPSS in 345. I'll see what my options in the 315 size are.

My precious car I drove around in 305 -555Rs. It would get a little squiggly during rainstorms but I would just drive my truck if I knew ahead of time.

Sponsored

 

[Labradog]

Ordering the 89/82 springs and Steeda shock mounts tomorrow. Was also going to get some PP shocks/struts. Any bolts/nuts I should get at the same time? Any reason to do the Ford Performance jounce bumpers or just cut my base ones?

 

[Luisiv32]

What is my best choice for a non pp gt?

 

[08StangGT_CS]

Can't go wrong! The bottom pic is mine and a friends. I have a BMR kit and my friend has a Steeda set for comparo.

What spring setup are you running?

Edit: Saw it in your build thread. SP080. Your car's stance looks bad ass.

 

[BmacIL]

What is my best choice for a non pp gt?

Exactly what [MENTION=24889]Labradog[/MENTION] is ordering above.

 

[08StangGT_CS]

SP080s ordered. I think 2morrow’s pictures isn’t what finally made me decide. Pairing that with Steeda non Adj shocks/struts and their billet mounts.

 

[2morrow]

What spring setup are you running?

Edit: Saw it in your build thread. SP080. Your car's stance looks bad ass.

Thanks! You'll love em when you get em installed.

Post some pix when you do

 

[BMR Tech]

Revised SP083 Handling Spring pics, coming soon.

Front: 250lb/in with 5/8" to 3/4" drop
Rear: 980lb/in with a 1/2" drop

;)

 

[Rambl3r]

Revised SP083 Handling Spring pics, coming soon.

Front: 250lb/in with 5/8" to 3/4" drop
Rear: 980lb/in with a 1/2" drop

;)

Kelly, I'm sure this has been asked before but are there any plans to revise a rear performance spring with a 1" drop?

 

[BMR Tech]

Kelly, I'm sure this has been asked before but are there any plans to revise a rear performance spring with a 1" drop?

At this time, no.

 

[BMR Tech]

Revised SP083 Handling Springs

 

[robertwsimpson]

SP080 springs
25mm spacers in front
AM 20/10 Perf Pack replicas with 305 35R20s in the rear

 

[BMR Tech]

First 2018 with BMR SP089 Front, SP082 Rears!

 

[BmacIL]

First 2018 with BMR SP089 Front, SP082 Rears!

Can't say I care for the wheels, but the drop is :hail:

 

[Labradog]

Successful pre-Black Friday! Got new springs and dampers ordered. Busy next month so might not be installed until after the first of the year, but looking forward to the new ride.

Sponsored