Custom 88mm turbo build

[Kracken_GT]

It has come time to create a post to stay updated on the progress of my custom turbo build. Much of the work has been completed and tuning and minor details should be finished by early November.

To start here is the car pre-build, purchased in December 2016 it came with Vossen rims, lowering springs, short throw, ford racing exhaust, and kooks headers.

Sponsored

 

[Kracken_GT]

Here is after I installed the carbon fiber decklid

 

[Kracken_GT]

This is a recent photo while I was doing my 15" conversion. At this point I have most of my suspension work done, billet opg installed, lots of fabrication work done, and most piping except a small portion of the hot side complete. Sitting on the floor soon to be installed at this point is my 800hp DSS halfshafts and scavenger pump

 

[Kracken_GT]

15" welds fitted and 800hp DSS half shafts installed. Rear suspension consists of BMR irs lockout, BMR vertical links, Viking crusaders, Ford racing lowering springs, Steeda diff bushings along with the new half shafts and Baer system.

 

[Kracken_GT]

Current status of car everything is fitted, still have a piece of the hot side to fit as well as the Amerihood 3" carbon cowl hood and the exhaust dump (coming out front bumper). Also waiting on my boost leash controller.

 

[Kracken_GT]

Current engine bay pic

 

[gearhead2685]

Badass! who built the kit and what kind of numbers are you swining for?

 

[Kracken_GT]

Badass! who built the kit and what kind of numbers are you swining for?

I built the kit and hoping for 8-900hp (fingers crossed) on e85 and in the future do a air to water intercooler with a mmr block to push past the 1xxx mark

 

[Ponderthis]

That shit is bad ass, wish the compressor cover was black or something more sneaky lol...

 

[Kracken_GT]

That shit is bad ass, wish the compressor cover was black or something more sneaky lol...

It was matte black before but I wanted to go with the what the f%ck is in your bumper look.

 

[Pincushin3819]

This is f'in sick! Good job dude seriously one of the coolest builds I've seen on this platform.

 

[Pincushin3819]

Which Treadstone intercooler is that & what all did you do to make it fit? I just put there 1300hp 6in in mine with a Paxton.

 

[cobra199711]

Very impressed, nice work!!

 

[Ninjak]

Wow nice build. Interesting place to put the turbo as well. I would like to see how the piping is setup.

 

[5.oh]

Nice!

Sponsored