What did you do to your S550 Mustang today?!

[CNewell]

Picked up car yesterday, today is tint day at a local shop. 20% llumar atr series. Has helped with the heat quite well so far

Sponsored

 

[Coconut]

Picked up car yesterday, today is tint day at a local shop. 20% llumar atr series. Has helped with the heat quite well so far

Carpeted install bay, fancy..

 

[xArchangel79]

Slapped the 19" PP wheels on my GT. Sorry for the sucky pic.

Congrats... now have fun cleaning them. :frusty:

 

[jwhite]

Sold it!!!! It's not as bad as it seems, I've had my 16 GT 350 track pack for about 4 months now and just enjoy it much more. My GT/PP was fun and all, especially the supercharger but trying to keep up with both on General maintenance and cleaning,,,,

 

[HoosierDaddy]

Don't stick a rag in the intake tube ... if it got sucked in you'd be FUBARed.

Well I think it goes without saying it should be a rag too big to get sucked in. The rag should be at least long enough to hang thru the serpentine belt.

 

[CCCP1999]

Congrats... now have fun cleaning them. :frusty:

I gots a black car so it all comes out the same in the wash.

 

[wireeater]

I honestly think my tab just stretched a bit, now that I think about it. It is hard to say for sure though, as I immediately threw the tube into the dumpster.

That's what mine did. There was no way I was trying to remove the bolt. It didn't break anything pulling it out. It just stretches the area the on the tap that the bolt goes over. I took a little rubber cap off a step ladder legs, pressed the handle of a screw driver inside of it, warmed up the rubber and it made a nice, tight sealing cap for the intake as well.

 

[Dirtyblueshirt]

Happy Blend Day to my Mustang. It's been a horrible year.

 

[Agent_S550]

That's what mine did. There was no way I was trying to remove the bolt. It didn't break anything pulling it out. It just stretches the area the on the tap that the bolt goes over. I took a little rubber cap off a step ladder legs, pressed the handle of a screw driver inside of it, warmed up the rubber and it made a nice, tight sealing cap for the intake as well.

Just did mine. Honestly not that hard. If you have a PP like mine, you can stick your arm down by the valve cover, run it back to the fire wall and a ratchet 10mm wrench runs it off. I paid a lot of money for this car and I'm not okay with ripping things off. Just seems counter productive to keeping the car nice lol

 

[HISSMAN]

Just did mine. Honestly not that hard. If you have a PP like mine, you can stick your arm down by the valve cover, run it back to the fire wall and a ratchet 10mm wrench runs it off. I paid a lot of money for this car and I'm not okay with ripping things off. Just seems counter productive to keeping the car nice lol

Your will now be know as Skinnyarm McSkinnyface from this day forth.

 

[robertwsimpson]

I can't wait to do this on my car and see what all the fuss is about!

 

[Gigantor]

You have to be resourceful and mechanically inclined to perform this maneuver. . .patience too

 

[HISSMAN]

You have to be resourceful and mechanically inclined to perform this maneuver. . .patience too

I can't fit my arms back there. And I am very mechanically inclined..

 

[Gigantor]

I can't fit my arms back there. And I am very mechanically inclined..

Snap On is your friend

 

[Gigantor]

Another method


[ame]

Sponsored