I think I'm gonna zip tie it in 2 spots so it doesn't get pulled down, hopefully that should be ok.I'm just hoping for a recall and redesign. I'd gladly rip mine off and send it back to AM if MMD reengineers this without the gap. In the mean time I just bought bubble wrap and that gap is getting packed tight with it until further notice. I recommend people in my boat start doing the same...bubble wrap, newspaper, foam, whatevs it takes to block air from entering
I own the diffuser, it's being ripped because it's getting pulled down, just normal physics. I'm starting to get pretty angry about this, I hope MMD or AM says something about this.I'm not sure zip ties are going to save you since some of the pics show the fasteners are holding but the defuser is tearing /splitting