Wire tuck help

[S550Joe]

I spoke with Jules over at Armageddon and he was able to send me their 15-17 mustang wire tuck kit, but with revised brackets for the 18+ mustang. I was getting by just fine with the 15-17 instructions until it came to mounting and installing the ecu and fuse box brackets. They’re so different from the 15-17 bracket that I cannot figure out which bracket goes where or how the ecu or fuse box are supposed to mount to them. Jules has been unable to get in contact with his mustang tech, so the most help he’s given me so far is that they’re based off the on3 kit. I emailed them as well but have not gotten a response yet. Hoping someone around here would be able to give me some insight or maybe some photos of the on3 or Armageddon brackets installed. I’ve been trying to find a solution for a week now and really need to start getting this car back together.

Sponsored

 

[Rapid Red]

Just a suggestion, shoot some photos with a lighter background, as in outside.

Both sides could help, along with the ECU.

Lots of detail is not seen in these shots.

 

[S550Joe]

Just a suggestion, shoot some photos with a lighter background, as in outside.

Both sides could help, along with the ECU.

Lots of detail is not seen in these shots.

Good point. I’ll go snap some more photos

 

[HadoDemi]

I’ll be watching this with interest..

 

[S550Joe]

I’ll be watching this with interest..

I’ve reached out to people all over the internet for help and haven’t gotten any results yet. If I figure it out I’ll post the results here

Sponsored