When would you need mounting brackets for Quick latch QL hood pins?

Semp1

Well-Known Member

Jul 27, 2020

Thread starter
#1

It says mounting brackets might be needed but need to be fabricated by the purchaser. I’m not fabricating anything lol.

Sponsored

Edelbrock 2650 TVS blower, Custom Dynotune By JDM Engineering, American Racing 1-7/8x3“ Longtubes, Corsa Xtreme Catback Active Exhaust With Black Chrome Tips, ID1050x injectors, DW400 fuel pump, JLT 3.0 Driver & Passenger Side Oil Separators, Ford Performance 3.55 gears, MGW X-Spec Short Shifter, Raceseng Slammer 1.26lb Weighted Shift Knob, Steeda 35lb Spring & Perch Kit, Steeda IRS Subframe Support Brace, Steeda Ultra Lite 2 point G-Trac Brace, Steeda IRS bushings, Steeda sub-alignment bushings, Ford Performance Front & Rear Sway Bars, Ford Performance Lowering Springs For Magneride, Ford Performance (GForce) Half Shafts, Red “Bullit” Brembo Brake Caliper Replacement Kit, SVE Black SP2 Wheels With “Shelby GT350” Ford Center Caps, NITTO NT555G2 Tires 285/35 (fronts) & NT555Rii 305/35 (rears), RTR Front Chin Spoiler, RTR Bumper Vents, RTR Upper Grille w/LED & Lower Grille, RTR Hood Vents, Roush Winglets, Ford OEM GT500 rear diffuser & close out panel, HGP Quarter Louvered Windows, Anderson Composites ST Spoiler, Drake Muscle “Shelby GT-H“ Decklid Panel, Carbon Cartel Carbon Fiber mirror cap replacements. Interior Mods and Under The Hood Dress Up Mods =Too Many To List

When would you need mounting brackets for Quick latch QL hood pins?

Semp1

Well-Known Member

Similar threads