Roush Rear Spoiler Fastback

[ETCH]

Has anyone installed a Roush Rear Spoiler Fastback themselves? if so how hard would you say the install was? if you had a body shop install it, how much was the install? any pics, or videos

thanks

rich

Sponsored

 

[Strytnyne]

Wasnt too hard unless your uncomfortable about using a drill, the template makes it basically fool proof

 

[Poppacapp]

Me and a buddy did it in a couple hours. Just be sure when you put the template on the car that you dont have any raised areas. Make sure the template is flat against the paint everywhere.

Because the trunklid is rounded instead of flat, when you go to put the spoiler on the car, it will appear that the studs wont go in the holes. Don't panic. It will.

Measure and check 14000 times.... drill once.

 

[ETCH]

Thanks, ill give a try. worse case... I buy a new trunk.... lol

 

[stevec]

Any pics from you guys that have installed it?

 

[ETCH]

Yeah any pics of the install, or video????? would really help out a lot

 

[Dark Horse GT]

Yeah any pics of the install, or video????? would really help out a lot

+1

 

[Strytnyne]

Yeah any pics of the install, or video????? would really help out a lot

didn't think about taking any pictures x.x

 

[rvlyssup]

From an M6G member on YT: [ame]

 

[ETCH]

From an M6G member on YT:

man i really like the look of the spoiler when mounted, but i really am not up to drill into my trunk. i have a buddy at work i think ill have to buy some pizza and beer to come over and do that part for me. beer after the work of course....

 

[stealthfrc]

i think the hardest part of the install was tightening the inside nuts.... what a pain in the ass that was...

 

[Dark Horse GT]

i think the hardest part of the install was tightening the inside nuts.... what a pain in the ass that was...

I will be finding out soon [emoji106]

Sent from my SAMSUNG-SM-N910A using Tapatalk

 

[stevec]

Great video. Good to see one being fitted.
Certainly like this spoiler more than the cdc one. Hoping to see more info on the rtr before I make my final choice.

 

[Poppacapp]

The nuts were easy to tighten.. just be careful not to drop them the part I hated was when we did the hole saw, the metal cutout pieces fell in the lid.. in there somewhere.. will try to fish them out with slim magnets sometime later.

One NOTE.. important... be sure to make note of the inner drill holes... it takes a different smaller sized drill bit. Follow the instructions to the T.

Sponsored