It WILL fit in any round vent location, but you may not have clearance for gauge depth behind the center vent due to the splitter (unless you cut it). The pod is sized for a 2-1/16" gauge. I believe that will fit the adapter cup on the nGauge (you'll want to check) but I do NOT believe that the nGauge outer bezel would fit within the chrome ring of the vent. Most nGauge mounts that I've seen replace the entire vent cup.Will this fit in any vent location? and will an NGauge fit?
Pull off the dash piece bottom right passenger side (spring clips), remove the bolt holding the bottom of the long dash piece, pull out long dash piece (spring clips) all the way to the cluster. Pop out a vent (I recommend the left one), separate it (clips), remove the vent flaps piece, insert gauge pod+gauge, reassemble. It’s all very straight forward once you start disassembling it.Looks great - So what are the steps to installing this? I had similar set up on my 2006 for boost and AFR and was telling my wife I needed something since my car doesn't have the performance pack gauges and the center screen only lets you see one thing at a time.