Tugger50H
Well-Known Member
- Thread starter
- #1
Went back down to the 3.48. Currently have a K060994HD belt (broke my last belt at the track and this is what I came across in the pits). The furthest to the right hole is where I had it with my 3.6 pulley and didn't notice any slip however it seemed excessively loose with the 3.48.
Now i'm on the second hole belt went on with out too much trouble with my ARS tensioner but curious if the clearance is too tight. Have about 1/4" clearance between the tensioner and the idler pulley above. Will this be an issue? Looking to move to 8 rib within the next month but if I need to go to a K060997HD or K061000HD id rather not break another belt. lol
Now i'm on the second hole belt went on with out too much trouble with my ARS tensioner but curious if the clearance is too tight. Have about 1/4" clearance between the tensioner and the idler pulley above. Will this be an issue? Looking to move to 8 rib within the next month but if I need to go to a K060997HD or K061000HD id rather not break another belt. lol
Sponsored
