TheRestorer
Active Member
- Thread starter
- #16
Finally she's complete again..
Sponsored
Sponsored
Parts diagram request for front bumper
- Thread starter TheRestorer
- Start date
- Watchers 5
TDC
Well-Known Member
- Joined
- Jan 27, 2015
- Threads
- 45
- Messages
- 2,244
- Reaction score
- 1,365
- Location
- Long Island
- Vehicle(s)
- 2016 GT350, 2019 Challenger Scat Pack Widebody, 2019 Corvette Grand Sport
Congrats. Now it's time to enjoy it!
ITLRUN
HiPo Joe
- Joined
- Dec 20, 2014
- Threads
- 42
- Messages
- 834
- Reaction score
- 902
- Location
- Adairsville, GA
- First Name
- Joe
- Vehicle(s)
- 2017 GT350R HR186
I have a broken "fang" on my car too, (http://www.mustang6g.com/forums/showthread.php?t=45905). Can you enlighten me where these three 7mm are located? I need to swap mine out too. Thanks!
TheRestorer
Active Member
- Thread starter
- #19
After looking at the part again, there are only 2 screws, so the 3rd one I removed was part of the supporting structure behind the bumper. One of the screws is on the far edge behind the snap holding the wheel well liner in place. The other is up higher on the opposite end. Pics of the locations are below, you do have to remove several snaps and pull back the wheel well liner, but I was able to access them without pulling the tire. It took me 3 tries to get the right part ordered through the dealership so to save some trouble the part number for mine was FR3V-17E811-A. Hope this helps.
Sponsored
