P0556 and p2198 after odin install

[Adamone92]

anyone ever have these codes before? Installed odin supercharger recently. Went for a short drive. After i came back to the car after it sat for 10mins or so, it started idling weird and threw these codes. I swapped the bank 2 upstream o2 sensor, deleted cats, checked connections, still have the issue. Wondering if anyone has had this before. Vacuum leak? Leaky fuel injector? Im trying to figure it out but thoughts and opinions are appreciated. Car drove fine prior to this.

Sponsored

 

[Adamone92]

More info too, car also drives rough and is running rich.

 

[RaGwEeD]

More info too, car also drives rough and is running rich.

I know this is an old thread, but....
Did you ever come up with a solution for the P2198 code? My 17 with a whipple just set P2198. I pulled the plugs on bank 2 and didnt see anything out of the norm for reading plugs. I have a new ford upstream 02 sensor to install this weekend. Going to data log some more this weekend as well, nothing earth shattering on that front, so far.

 

[MKL_DS]

I know this is an old thread, but....
Did you ever come up with a solution for the P2198 code? My 17 with a whipple just set P2198. I pulled the plugs on bank 2 and didnt see anything out of the norm for reading plugs. I have a new ford upstream 02 sensor to install this weekend. Going to data log some more this weekend as well, nothing earth shattering on that front, so far.

Did you mess with the o2 sensors? Add extension harnesses?

 

[RaGwEeD]

Did you mess with the o2 sensors? Add extension harnesses?

Nope, still has all factory parts including cats. The whipple has been on for about 4500 miles. Data logs are showing something odd. This is manual car, when on the highway, if put in neutral at say 65 mph the idle drops to 250 and surges to 750. When it is doing this the AFR goes down to .7. When around town, say 25 mph and put in neutral all is good, AFR stays right around .96 to .99.

 

[MKL_DS]

MAF turbulence?

 

[RaGwEeD]

MAF turbulence?

Very well could be, to the best of my knowledge the Tomahawk tool doesn't show MAF values or voltages.

Sponsored