OFFSET help

[MELLOWYELLOW06]

I want to get a square setup on my car but want to go with 10.5" wheels.

I have the PP on my car and want to lower in the near future.

I have seen 40 offset on 10" work with Niche with 275/35.

But what would I need as an offset for 10.5 to be flush yet not catch anything on the inside?

If I use that same size tire, 275/35/20 on 10.5, it will help stretch the tire so it wont catch anything in the fender

Thanks in advance for any help with this.

Sponsored

 

[EuroBoy]

I think +30 will work for 20x10.5

275 35 20 should be pretty good. the size is usually cheaper than other sizes of 20" diameter.

you might even be able to do 275 40 20

 

[jayman33]

If you decide to go coilovers you'll get an extra 5-8mm of clearance most likely switching to a smaller spring.

 

[MELLOWYELLOW06]

If you decide to go coilovers you'll get an extra 5-8mm of clearance most likely switching to a smaller spring.

most likely going with the pro kit.

could it work?

 

[jayman33]

Don't know 100%, its one of the things I have to test fit.

What wheels?

 

[MELLOWYELLOW06]

Not sure yet

 

[Brian@Vossen]

Our 20x10.5 +45 might work. I think you will need a 5mm spacer up front though so the center cap clips in. We noticed there is a black piece on the hub that could prevent the cap from going all the way in.

 

[MELLOWYELLOW06]

Our 20x10.5 +45 might work. I think you will need a 5mm spacer up front though so the center cap clips in. We noticed there is a black piece on the hub that could prevent the cap from going all the way in.

I was thinking more like a 10 mm spacer putting it at 35.

You don't think 40 offset on a 10.5 will hit the strut body?

You should try your rear 45 offset up front and see where it sits.

You may discover a whole new square set up look!

 

[Vossen Wheels]

I was thinking more like a 10 mm spacer putting it at 35.

You don't think 40 offset on a 10.5 will hit the strut body?

You should try your rear 45 offset up front and see where it sits.

You may discover a whole new square set up look!

20x10.5 at a +35 will be perfect even with a 285/35/20!

We currently offer 20x10.5 +45/25 but the 25 may poke too much and the +45 would require a 10MM spacer to run the 285/35/20 and have enough clearance from the inner strut.

Rear you're good with 20x10.5 +45 315/30/20!

Front I would recommend our 20x9.5 +25 with no spacer and a 275/35/20 tire

 

[MELLOWYELLOW06]

20x10.5 at a +35 will be perfect even with a 285/35/20!

We currently offer 20x10.5 +45/25 but the 25 may poke too much and the +45 would require a 10MM spacer to run the 285/35/20 and have enough clearance from the inner strut.

Rear you're good with 20x10.5 +45 315/30/20!

Front I would recommend our 20x9.5 +25 with no spacer and a 275/35/20 tire

Thanks Diego.

I like the profile of the 10.5. I like how the 315/35 looks out back. On the 9.5, the profile looks good but the tire looks real swollen, FOR MY TASTE AT LEAST.

If we were to put Brians 275/35/20 on a 10.5, That extra inch would give it a decent stretch, so it will look wide yet not as swollen. Are you confident it wont hit on the fender or the inside with that width and tire size?

 

[Vossen Wheels]

Thanks Diego.

I like the profile of the 10.5. I like how the 315/35 looks out back. On the 9.5, the profile looks good but the tire looks real swollen, FOR MY TASTE AT LEAST.

If we were to put Brians 275/35/20 on a 10.5, That extra inch would give it a decent stretch, so it will look wide yet not as swollen. Are you confident it wont hit on the fender or the inside with that width and tire size?

I am confident it would clear just fine with a 275/35/20 on a 20x10.5 +35. That would be my choice of fitment on this car but would require a spacer with our 20x10.5 +45. 20x10.5 +25 with 275/35/20 would make contact with fender so I won't recommend that.

 

[Vossen Wheels]

Another option would be our Mid-Face concave 20x9.5 +25 F&R with 265/35/20 if you feel the 275/35/20 is too big for this width.

 

[MELLOWYELLOW06]

I like the rears on Brians and I think the stretch on a 10.5 would be great up front. Just scared the rim wouldnt work up front with the toyo 4 plus

Sponsored