Sponsored

Next mod?? Any recommendations

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
Hello ecostangs

Like always im looking to improve my ecostang but i need recommendations for my next mod. My current mods are listed below on my signature. I was thinking of getting new spark plugs but im not sure which brand to get. Any suggestions on other mods other than the spark plugs? Not trying to spend too much money on my next mod but feel free to give any suggestions :cheers::thumbsup:
Sponsored

 

BlackBoostedStang

Well-Known Member
Joined
Oct 7, 2015
Threads
19
Messages
273
Reaction score
112
Location
Orlando
First Name
Scott
Vehicle(s)
2015 Mustang GT
i just installed the tune+ pre-gapped plugs yesterday afternoon and the car immediately accelerated smoother
 

Jasber

Well-Known Member
Joined
Nov 10, 2014
Threads
7
Messages
329
Reaction score
79
Location
Corinth, TX
First Name
Jason
Vehicle(s)
2015 Mustang Ecoboost Ingot Silver
Tune+ Wastegate Actuator upgrade and the tunes for life from Adam!
 

okanizer3

Active Member
Joined
Apr 15, 2016
Threads
9
Messages
30
Reaction score
3
Location
Northwestern NJ
First Name
Okan
Vehicle(s)
2015 Ecoboost w/PP
Put in some suspension mods... my mods for my ECOBOOST with PP are listed below... Car drives so much differently with the suspension upgrades.


Mod List:
Unleashed Tune
Mishimoto inter cooler kit with hot/cold side pipes
Turbo smart dual valve BOV
MBRP cat back exhaust system Race
MRT high flow catted downpipe
Roush Cold Air Intake
Steeda Throttle Body Spacer
Oil Catch Can Upr dvcc with boomba check valve
Ford Street lowering springs 1"
Ford track strut/shock package
Steeda Rear subframe support braces
Steeda Extreme G trac K Member Brace
Steeda differential red insert bushings
Steeda subframe alignment bushings
Boomba short throw shifter
Boomba transmission bushing
Steeda shifter bushing
 

Sponsored

OP
OP
Djmike408

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
Thanks for the suggestion [MENTION=11484]Jasber[/MENTION] [MENTION=18987]BlackBoostedStang[/MENTION] yea i was thinking the same thing about the wastegate but what about Water Methanol injection? How safe is it to install them?
 

v8440

Well-Known Member
Joined
May 3, 2016
Threads
10
Messages
268
Reaction score
48
Location
AL
Vehicle(s)
2016 gt
Properly done, water/meth is very safe.
 
OP
OP
Djmike408

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
[MENTION=23283]okanizer3[/MENTION] I want one more mods before i start the suspension. I was looking at Water Methanol injection to add more hp and torque. Just trying to get all I can only the stock turbo. But thanks for the recommendation your mods look great wish I could see some pictures of your stang :)
 

Lexman

Well-Known Member
Joined
Nov 8, 2015
Threads
20
Messages
317
Reaction score
67
Location
Chicago, IL
Vehicle(s)
2016 Ruby Red Mustang GT Premium
The Wastegate is considered the most bang for the upgrade for power. People have been surprised how much it improved the car. Meth is another option and has other benefits besides power (believe it helps with keeping things clean running cooler).

Adam has the wastegate before exhaust, downpipe, or CAI as power increase mod.
 
OP
OP
Djmike408

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
[MENTION=19644]Lexman[/MENTION] yea ima make my gf buy me the wastegate lol also what brand do you recommend to get for the Water Methanol injection kit? How easy is it to maintain? Any cons? Can u remove it anytime you want?
 

Sponsored
OP
OP
Djmike408

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
[MENTION=23728]v8440[/MENTION] any suggestions on brands for the Water Methanol injection kit? how easy is it to maintain? any cons?
 

KadenW23

Well-Known Member
Joined
May 9, 2016
Threads
8
Messages
111
Reaction score
16
Location
Dallas, TX
First Name
Kaden
Vehicle(s)
2015 Mustang Oxford White Ecoboost
[MENTION=23728]v8440[/MENTION] any suggestions on brands for the Water Methanol injection kit? how easy is it to maintain? any cons?
Snow Performance has a stage 3 kit make specifically for our cars. But I believe that you can buy just any old kit to install, nothing really sets the snow performance kit apart from any other kit, other than the controller.

Pros: reduces your charge air temps dramatically, keeps the cylinders clean of most carbon build up, increases the octane of your fuel significantly, HP gains when tuned right are vary satisfying for the price you pay for an overall kit.

Cons: You MUST get a custom tune to run a meth system, you Must always have 50/50 mix (or whatever you shoes to run) in the holding at all times because if you don't, then your engine will not be tuned correctly and it could cause major damage to your engine, (not really a con) but something you may run into is trying to figure out where you want to place your injector for there are many places. ive seen people to it pre-turbo, post- turbo/pre-intercooler, but 90% of people ive seen will do it right before the intake manifold which seems to be the easiest because there are companies like boomba who make a throttle body spacer to accommodate for a meth system injector directly through the side on the spacer.

But overall a meth kit is a fairly safe and reliable way to squeeze a little bit more power out of our turbo charged cars, but it is not something you can install and just never check on it. So just be prepared for the maintenance. :cheers:
 
OP
OP
Djmike408

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
[MENTION=23881]KadenW23[/MENTION] thanks for the feedback bro :) so from what you are saying as long as i install the kit correctly and always have 50/50 mix juice on hand with the right Tune and tuner combo I should be safe and ready to go? Also I don't have to replace any hoses regularly or anything else?
 

KadenW23

Well-Known Member
Joined
May 9, 2016
Threads
8
Messages
111
Reaction score
16
Location
Dallas, TX
First Name
Kaden
Vehicle(s)
2015 Mustang Oxford White Ecoboost
[MENTION=23881]KadenW23[/MENTION] thanks for the feedback bro :) so from what you are saying as long as i install the kit correctly and always have 50/50 mix juice on hand with the right Tune and tuner combo I should be safe and ready to go? Also I don't have to replace any hoses regularly or anything else?
Its always safe to check your hoses probably every six months just to be safe, if you were running just straight meth or alcohol, both of those are extremely corrosive and degrading to your hoses and pump over time but if you keep a 50/50 mix you should be alright for quite awhile. but yeah, nice thing about that stage 3 kit is that it comes with a low fluid light that your route to your interior which makes it much easier to monitor the level and stay on top of it.

I would say, just do some research and see what works best for everyone else, doesnt take long at all to scroll through some forums and read about meth injection as a whole, it will also gives you a thorough understanding of how these kits work so when it comes to installing them it will be a breeze.
 
OP
OP
Djmike408

Djmike408

Well-Known Member
Joined
Feb 10, 2016
Threads
41
Messages
232
Reaction score
14
Location
California
Vehicle(s)
Ecoboost
[MENTION=23881]KadenW23[/MENTION] I was looking at the Snow Performance Boost Cooler Stage 2 with the Snow Boost Juice. Now do you know if i need a throttle body spacer for this kit? are u able to active or deactivate this kit when needed? Let's say if i ran out of juice and don't got any in hand?
Sponsored

 
 








Top