Need help with vacuum line placement on turbo car

[Slaughter5.0]

I need to know where to put these to lines that where in the stock intake tube? One is the right side of the throttle body , I used the left side for the race motion vacuum block

Sponsored

 

[Chicken hawk]

This is a very good question. I am installing a twin kit myself and need to know this answer. Have you figured this out already and if so can you show a pic on how it goes?

 

[Slaughter5.0]

This is a very good question. I am installing a twin kit myself and need to know this answer. Have you figured this out already and if so can you show a pic on how it goes?

Yes which lines are u referencing 2 lines go to the intake flap control valves and one to the brake booster, I deleted the control valves and hooked the brake booster up to the intake I’ll send pics if needed

 

[Jackson1320]

The brake can go straight to the intake manifold but you have to use a check valve or you can mess up your booster and you can have problems with brake pressure

 

[Slaughter5.0]

The brake can go straight to the intake manifold but you have to use a check valve or you can mess up your booster and you can have problems with brake pressure

I used the check valve that was on
It just capped unused ports on it

 

[Jackson1320]

I used the check valve that was on
It just capped unused ports on it

I used a inline check valve so it would look clean but ether way works

 

[Slaughter5.0]

I used a inline check valve so it would look clean but ether way works

Where did u get ur inline check valve? It would look better thanks in advance

 

[K4fxd]

The brake can go straight to the intake manifold but you have to use a check valve or you can mess up your booster and you can have problems with brake pressure

What???

Please explain.

Mine is hooked straight to the intake manifold ALA GT350

 

[Jackson1320]

What???

Please explain.

Mine is hooked straight to the intake manifold ALA GT350

The brake booster should only see vacuum no boost. So you install a check valve so that the boost pressure is stopped before it damages the booster

 

[K4fxd]

The brake booster should only see vacuum no boost.

Got it, I missed the boosted part.

 

[Slaughter5.0]

What???

Please explain.

Mine is hooked straight to the intake manifold ALA GT350

The check valve prevents boost from being put into brake booster , allows vacuum but prevents boost

 

[Chicken hawk]

This pic with the line resting between your thumb and your index finger is the line I’m trying to figure out what I do with. Do I just plug this line? Maybe you have answered this and I’m overlooking the answer.

 

[K4fxd]

Hard to say because your arrow is covering it up

 

[Slaughter5.0]

Hard to say because your arrow is covering it up

Cap all the lines that are open, u should have two going to ur intake control flaps and one to the brake booster.

 

[Chicken hawk]

Hard to say because your arrow is covering it up

The arrow isn’t covering the line I am referring too. I am referring to the one on the left in between the thumb and index finger. No worries though I appreciate any feedback that anyone may have .

Sponsored