GTP
Deutsche Pony
- Joined
- May 27, 2015
- Threads
- 201
- Messages
- 4,472
- Reaction score
- 2,313
- Location
- Indy
- Website
- www.BambergAudio.com
- First Name
- Philip
- Vehicle(s)
- 2019 GT PP1 A10 Outrageous Orange HPDE mods
- Thread starter
- #1
I just installed a square setup of Enkei TY-5 in 19x9.5".
The information provided me was that the center cap would barely clear the front hub dust cap.
So I put on 1/4" spacers. There were 7 threads engaged, so that part was good.
I decided to measure the clearance myself.
Minimum putty thickness looked to be only about 1mm. Clearance, barely!
Bonus pics:
The Ford scissors jack works with the Steeda jacking rail, if you place it carefully.
The small-pattern tuner lugs fit the spare tire sufficiently well.
The information provided me was that the center cap would barely clear the front hub dust cap.
So I put on 1/4" spacers. There were 7 threads engaged, so that part was good.
I decided to measure the clearance myself.
- Bought some Silly Putty at the dollar store.
- Took off the wheel, and removed the spacer.
- Put the putty over the hub dust cap.
- Replaced the wheel, then took it off again.
- Cut the putty in half with scissors.
Minimum putty thickness looked to be only about 1mm. Clearance, barely!
Bonus pics:
The Ford scissors jack works with the Steeda jacking rail, if you place it carefully.
The small-pattern tuner lugs fit the spare tire sufficiently well.
Sponsored