Harness Bar?

[FPCV8YO]

I think the cool tech is what they have in the Track Attack cars. Can anyone confirm this?

Looks like the Watson requires rear seat delete while the cooltech does not. Not that the seats are useful before or after the roll bar install.

Was the back seat still in? It's my understanding that the Watson installation requires the removal of the back seat where the Cool Tech does not.

Sponsored

 

[Steve68]

The car I had had rear seat delete. But iirc, the bars going to the trunk area weren't going through the delete panels. I could be wrong.

 

[Bender]

I was told at the Track Attack they are Watson roll bars. I am planning on the RSD anyway so I will be going with Watson

 

[SchultzLT1]

I like the Watson, but am just very curious about how badly it will hurt resale.

 

[Steve68]

Or help...depends on who's buying it, eh.

 

[krt22]

I like the Watson, but am just very curious about how badly it will hurt resale.

Just remove it before you sell it and leave the trim panels out or get a spare set to trim.

 

[Super Werty]

Says on their site no drilling. Where are you guys seeing otherwise? Either way I don't mind but it does say it uses factory holes on the front gussets...

http://shop.watsonracing.com/mobile...S550-4-Point-Roll-Bar-p/wr-15-boltincage.htm=

 

[stoli]

Says on their site no drilling. Where are you guys seeing otherwise? Either way I don't mind but it does say it uses factory holes on the front gussets...

http://shop.watsonracing.com/mobile...S550-4-Point-Roll-Bar-p/wr-15-boltincage.htm=

Page 7 of the install instructions:

22)With the rear legs in place, fully tighten the 6 main hoop-to-body bolts, and the bolts atthe machined joints. Confirm that rear legs/bar are still in proper location. Mark theholes to be drilled with a centering-punch, and remove the rear roll bar legs.

It's nothing major, but does require some drilling.

 

[Super Werty]

Ah OK... Well that's no biggie at all

Sponsored